Dmx512 Connection; Connection With Mains; The Use Of Gobo Frame - Vello LED Profile 250 User Manual

◼
Please use qualified safety-rope, which can hold at lease 10 times the weight of the fixture. You must only
use safety-ropes with quick links with screw cap. Pull the safety-rope through the hole on the bottom of the
base and over the trussing system etc. Insert the end in the quick link and tighten the fixation screw. A
safety rope which already hold the strain of a crash or which is defective must not be used again.

2.DMX512 connection

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120Ω resistor
between Signal (－) and Signal (＋) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.Please
use qualified xlr-xlr dmx cables.

3.Connection with mains

◼
The person involved with the power connection must be qualified, and has the electrical engineering
certificate.
◼
Connect the device to the mains with the power plug.
◼
The earth has to be connected.
◼
Power consumption 250W, input power supply AC100V-250V, 50Hz/60Hz.

4.The use of gobo frame

◼
Take out the gobo frame, loose the screws insert the gobos and lock the screws again.
◼
Insert the gobo in the slot.
- 3 -