Advertisement
Maximum housing temperature: 75℃
Minimum distances
Min. distance from flammable surfaces: 3.0m
Min. distance to lighted object: 2.0m
Dimension: 386(L) x 365(W) x 589(H) mm
Weight (net): 19kg
Warranty: 1 Year
.................................
Set Up:
Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the required voltage for unit, The model
is Auto power supply, It is workable in 100-250V/50~60Hz. Please make sure your unit voltage matches the wall outlet voltage before
attempting to operate you fixture.
Connection to the mains
For protection from electric shock, the fixture must be earthed!
Install a suitable plug on the power cord, note that the cores in the power cord are colored according to the following table. The earth
has to be connected!
If you have any doubts about proper installation, consult a qualified electrician.
Core (EU)
Core (US)
Connection
Plug Terminal Marking
L
Brown
Black
Live
N
Light blue
White
Neutral
Yellow/Green
Green
Earth
DMX512 connection
The fixture is equipped with both 3-pin and 5-pin XLR sockets for DMX input and output. The sockets are wired in parallel.
Only use a shielded twisted-pair cable designed for RS-485 and 3-or 5-pin XLR-plugs and connectors in order to connect the controller
with the fixture or one fixture with another.
DMX-output
DMX-input
XLR mounting-sockets (rear view):
XLR mounting-plugs (rear view):
DMX Linking: To ensure proper DMX data transmission, when using several DMX fixtures try to use the shortest cable path possible.
The order in which fixtures are connected in a DMX line does not influence the DMX addressing. For example; a fixture assigned a DMX
address of 1 may be placed anywhere in a DMX line, at the beginning, at the end, or anywhere in the middle. When a fixture is assigned
a DMX address of 1, the DMX controller knows to send DATA assigned to address 1 to that unit, no matter where it is located in the
DMX chain.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always connect one output with the
input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120Ω resistor between Signal (－) and
3
Advertisement
