Table of Contents
Advertisement
●
Never operate this unit when its rear cover is removed.
●
Never plug this unit into a dimmer pack.
Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6" (15cm) between
●
this device and a wall.
●
Do not attempt to operate this unit, if it becomes damaged.
●
During long periods of non-use, disconnect the units main power.
●
Always mount this unit in safe and stable matter.
●
Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to the point they exit from the unit.
Cleaning unit should be cleaned only as recommended by the manufacturer. See 'Cleaning" for details.
●
Heat –The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or
●
other appliances (including amplifiers) that produce heat.
●
The unit should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits s marked change in performance.
INSTALLATION
1.Installation
◼
When installation, keep the device far away the heat sensitive objects and explosives sensitive objects,
leave at least 50cm of free space around the device.
◼
When the device put on horizontal place, the device must be placed directly on the place, and device must
be secured with a mounting holder.
◼
When ring the devices on the truss and the head face to the floor. Screw one clamp each via a M12 screw
and nut onto the mounting holder. Insert the quick-lock fasteners of the first mounting holder into the
respective holes on the bottom of the device. Tighten the quick-lock fasteners fully clockwise. Install the
second mounting holder. And the safety rope must be used at same time.
- 2 -
Advertisement
Table of Contents
