5.Use iris
The fixture delivers without Iris; user can purchase the iris if needed. Loose the screws and insert the iris.
6.Replace fuse
◼
Before replacing the fuse, unplug mains lead.
◼
Procedure:
Step1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing
(Anti-clockwise).
Step2: Remove the old fuse from the fuse holder.
Step3: Install the new fuse in the fuse holder.
Step4: Replacing the fuse holder in the housing and fix it.
7.Focus
◼
The objective lens cylinder is usually shrieked before leave factory, after connect the projector to the mains,
user may loose the screws and pull out the lens cylinder, till the white light output circular is clearly
presented, locking tightly the two screws again.
◼
When the projection distance is changed, user can follow previous operation steps, and focus the projector.
8. Zoom control
◼
The fixture allows you to adjust beam range from 15degree to 55degree manually.
1.Control Board
◼
MENU
◼
UP
◼
DOWN
◼
ENTER
2.MENU DISPLAY
- 4 -