Controller Module - NetApp FAS2600 Manual

If your system is running
ONTAP...
With two nodes in the cluster
With more than two nodes in the
cluster
In a stand-alone configuration
Resulted in some test failures
Step 3: Return the failed part to NetApp
After you replace the part, you can return the failed part to NetApp, as described in the RMA instructions
shipped with the kit. Contact technical support at
638277 (Europe), or +800-800-80-800 (Asia/Pacific) if you need the RMA number or additional help with the
replacement procedure.

Controller module

Replace the controller module - FAS2600
You must review the prerequisites for the replacement procedure and select the correct
one for your version of the ONTAP operating system.
• All drive shelves must be working properly.
• If your system is in an HA pair, the healthy node must be able to take over the node that is being replaced
(referred to in this procedure as the "impaired node").
• This procedure includes steps for automatically or manually reassigning drives to the replacement node,
depending on your system's configuration.
36
Then...
Issue these commands:
-configured true node::> storage failover modify
-node node0 -enabled true
Issue this command:
node::> storage failover modify
-node node0 -enabled true
You have no further steps in this particular task.
You have completed system-level diagnostics.
Determine the cause of the problem.
a. Exit Maintenance mode:
b. Perform a clean shutdown, and then disconnect the power
supplies.
c. Verify that you have observed all of the considerations identified
for running system-level diagnostics, that cables are securely
connected, and that hardware components are properly installed
in the storage system.
d. Reconnect the power supplies, and then power on the storage
system.
e. Rerun the system-level diagnostics test.
NetApp Support, 888-463-8277 (North America), 00-800-44-
node::> cluster ha modify
halt