Before Testing; Calibration; How To Code Your Meter (For Β-Ketone/ Total Cholesterol/ Uric Acid Test); Checking The Code Number - Fora 6 Plus Owner's Manual

Before Testing

Calibration

You must calibrate the meter every time you begin to use a new vial of β-ketone/
Total cholesterol/ Uric acid test strips by setting the meter with the correct code.
Test results may be inaccurate if the code number displayed on the monitor does
not match the number printed on the strip label or strip foil pack.
How to Code Your Meter (for β-ketone/ Total cholesterol/ Uric acid test)
1. Insert the code strip when the monitor is off. Wait until the code number
appears on the display.
Note:
• Make sure the code numbers on display, code strip, and test strip vial or foil
pack are the same. The code strip should be within the expiry date; otherwise,
an error message may appear.
2. Remove the code strip, the display will show "OFF". This tells you that the
meter has finished coding and is ready for β-ketone/ Total cholesterol/ Uric
acid testing.

Checking the Code Number

You need to make sure that the code number displayed on the meter matches
the number on your test strip vial or foil pack before you proceed. If it matches,
you can proceed with your test. If the codes do not match, please stop testing
and repeat the calibration procedure. If the problem persists, contact Customer
Service for help.
NOTICE:
The codes used in this manual are examples only; your meter may display a
different code.
WARNING:
• It is important to make sure that the LCD displayed code is the same as the
code on your test strip vial or foil pack before testing. Failure to do so will get
inaccurate results.
• If the LCD displayed code is not the same as the code on your test strip vial
and the code number cannot be updated, please contact Customer Service for
assistance.
11