Table of Contents
Advertisement
•
To prevent breakage, never extend the lock-off arm
beyond its normal open position and always keep
the lock-off closed when not in use.
•
If your vehicle is equipped with an automatic locking
retractor (ALR), use of the lock-offs is not required
as long as the ALR is locked. Check your vehicle
owner's manual to determine what type of retractor
your vehicle has and how to lock the retractor.
8
Verify that the vehicle belt is tight and that the
child seat is secure.
•
The child seat is secure when it cannot be moved
more than 2.5 cm (1 in.) front-to-back or side-to-
side at the belt path. If the child seat is not secure,
repeat the procedure or use an alternate seating
location .
•
When properly installed in the rear-facing position,
the back angle of the child seat should be 30º – 45º
from vertical (not to exceed 45º) when the car is
parked on a level surface (Fig. G).
•
If necessary, the proper recline angle can be
achieved by placing a rolled towel or pool noodle
in the crease of the vehicle seat to level the child
seat's base.
WARNING!
the front edge of the vehicle seat. This could
cause your child seat not to perform as intended.
•
Rear-facing installation can be improved by the use of the Versa-Tether.
See pages 25 – 27.
Do not raise the child seat off
Installation : Rear-facing
e
f
0º
G
30–45º
90º
15
Advertisement
Table of Contents
