Table of Contents
Advertisement
Step 13
Fit the stand-off posts to the board.
•
The black plastic posts are fitted to the copper side of the board, whereas the
•
small plastic screws are fitted to the DECAL side of the board.
Tighten the screws but do not over-tighten them, as this will damage the thread
•
on the screw.
Congratulations!
Congratulations, you have now completed the kit.
Copyright © 2018 - 2019
www.yoofab.com
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
G.D.COWNE - MØOOZ
page 66 of 66
Advertisement
Table of Contents
