Table of Contents
Advertisement
Connectors
1. Power supply - The circuit is powered using a 6 - 16 Volt DC supply. This is
connected to the circuit using a standard 2.1mm Power jack, with the centre pin
as ++. The supply must be clean (free from noise or ripple from the mains).
Indeed, you should probably use a 9V battery to test the antenna loop.
2. RF output - The Active Antenna Loop output uses an RCA socket. This makes
the loop amplifier compatible with YooFab RFLEGO. However, you may need to
use an adaptor or make your own cable if you need to connect this to
UHF
type connectors.
3. Wire Loop A and B - Two Banana sockets allow the connection of a 1 - 1.5
meter length of wire. Your kit includes a length of galvanized wire, which
may be fashioned into a loop. This is thin wire, yet has enough rigidity to
maintain a form. Note that the form does not have to be circular. Indeed you may
experiment with different shapes and the use of other types of wire.
Copyright © 2018 - 2019
www.yoofab.com
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
G.D.COWNE - MØOOZ
BNC
or
page 12 of 66
Advertisement
Table of Contents
