So where are the leads soldered onto the PCB?
1. The two dots shown above against the leads of the right hand side of the toroid,
show the 'top' of each pair of wound wires.
2. On the left, is the other side of these dotted wires. You can test this with a
continuity meter.
3. The two wires that go to C4 and C5 are one winding
4. The two other wires are the other winding or pair. One side of which is soldered
to ground and the other to the output track.
Copyright © 2018 - 2019
www.yoofab.com
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
G.D.COWNE - MØOOZ
page 60 of 66