Supervisor/User Password - MSI TX98 Manual

Enabled this item, push the Power Button. The system will go to suspend mode,
if press the button continuos more than 4 sec, the computer will power off.

3-9 SUPERVISOR/USER PASSWORD

This item lets you configure the system so that a password is required each time
the system boots or an attempt is made to enter the Setup program (Refer to Figure
3-3 for the details). Supervisor Password allows you to change all CMOS settings
but the User Password setting doesn ' t have this function. The way to set up the
passwords for both Supervisor and User are as follow:
1. Choose either Supervisor Password or User Password in the Main Menu and
press <Enter>. The following message appears:
" Enter Password: "
2. The first time you run this option, enter your password up to only 8 characters
and press <Enter>. The screen does not display the entered characters. For
no password just press <Enter>.
3. After you enter the password, the following message appears prompting you to
confirm the password:
" Confirm Password: "
4. Enter exact the same password you just typed again to confirm the password
and press <Enter>.
5. Move the cursor to Save & Exit Setup to save the password.
6. If you need to delete the password you entered before, choose the Supervisor
Password and Press <Enter>. It will delete the password that you bad before.
7. Move the cursor to Save & Exit Setup to save the option you did, otherwise the
old password will still be there when you turn on your machine next time.
35