Table of Contents
Advertisement
a. Turbo LED
The Turbo LED is always ON. You can connect the Turbo LED from
the system case to this pin.
b. Reset Switch
Reset switch is used to reboot the system rather than turning the
power ON/OFF. Avoid rebooting while the HDD LED is lit. You can
connect the Reset switch from the system case to this pin.
c. Power LED
The Power LED is always lit while the system power is on. You can
connect the Power LED from the system case to this pin.
d. Speaker
Speaker from the system case is connected to this pin.
e. HDD LED
HDD LED shows the activity of a hard disk drive. Avoid turning the
power off while the HDD led is lit. You can connect the HDD LED
from the system case to this pin.
f. Suspend Switch
This 2-pin connector is used to suspend the system.
2.19-4 USB Secondary Port: USB2
Connector for USB devices like: keyboard, mouse and other USB devices.
You can plug the USB device directly to this connector.
2.19-5 Power ON/Off Switch Connector: JSW1
Connect to a 2-pin push button switch. If Instant-on is Enabled, every time
the switch is shorted by pushing it once, the power supply will change its
status from OFF to ON. If Instant-on is Disabled: During ON stage, push
once and the system goes to sleep mode: pushing it more than 4 seconds
will change its status from ON to OFF. If you want to change the setup,
you could go to the BIOS Power Management Setup.
JSW1
2-39
Advertisement
Table of Contents
