Table of Contents
Advertisement
CHAPTER 2
Wake-Up on LAN Connector: WOL1
The WOL1 connector is used for LAN add-on cards that supports Wake Up
on LAN function. To use this function, set the "Wake-Up on LAN" to
enable located at the BIOS Power Management Setup.
1
3
WOL1
Note: LAN wake-up signal is active "high".
Note:
To be able to use this function, you need a power supply that
provide enough power for this feature. (Power supply with 750mA
5V Stand-by)
PIN
1
2
3
2-20
HARDWARE INSTALLATION
SIGNAL
5VSB
GND
MP_WAKEUP
Advertisement
Table of Contents
