Thermador PGR30 Care And Use Manual page 22

SECTION FOUR: USING THE COOKTOP
Disassembly/Assembly of the Grill
CAUTION:
• Use extreme care when placing the grill
components into the grill compartment.
Avoid contacting the ceramic igniter which
could break preventing operation of the
grill.
• The grill must be assembled as shown. The
drip tray heat shields must be in place, and
the burner must be properly positioned
relative to the gas supply. Incorrect assembly
of the grill may result in unsafe or hazardous
conditions during operation.
• Do not leave the grill unattended while in
use.
• Do not use charcoal briquettes or coals of
any kind.
Exploded Views and Side View of Grill
Grill
Grate
Stainless
Steel Radiant
U-shaped
burner
Heat
Deflector
Grill Box
Drip Pan
Follow the steps below to disassemble the compo-
nents in the grill box.
A. Remove the grill grate, stainless steel radiant and
burner from the grill box.
B. Remove the rectangular drip pan inside the grill box
as shown below.
C. Install the heat deflector into slots of front panel of
grill box.
D. Insert the end of the burner into the slots at the
back of the grill box. Insert the tab on front of the
burner into slot in the heat deflector.
E. The stainless steel radiant lies on two (2) studs on
each end of the grill can.
F. Place the grill grate, with raised food containment
rail oriented towards the grill box rear.
G. To reassemble the grill, follow these instructions in
reverse order.
Burner Placement in slots in back of grill
Page 20