Cleaning And Care; Technical Specifications - Vitek VT-2554 Manual Instruction

Body trimmer (4)
– The best results of using the face and body trimmer (4) are
achieved if your skin is dry. Before treating wet areas, such
as armpits, dry your skin with a towel.
– If the hair length is more than 20 mm, use scissors to cut
the hair to 2 or 5 mm for easier operation.
– During the operation place the face and body trimmer (4)
at a 45° angle. Always move the body trimmer (4) against
the hair growth direction.
– Trim thick hair with slow and sure movements. Stretch the
skin on the sensitive body areas.
– Сlean the face and body trimmer (4) right after the use.
Switching the unit on
– Install the attachment (4) to the installation place (3), and
turn it clockwise until bumping.
– Set the switch (2) to the position «ON».
– After you finish using the unit, set the switch (2) to the
position «OFF».
Note: always switch the unit off during the intervals in operation.

CLEANING AND CARE

– Switch the trimmer off right after use.
– Remove the attachment (4) by turning it counterclockwise.
– Clean the attachment off the cut hair with the brush.
– To clean the blades remove the cutting hair length adjuster
by pulling it upwards and clean the blades from the hair.
– Install the adjuster back to its place having preliminary
matched the marks «▲▼» on the adjuster and the trimmer
attachment body (4).
– Clean the trimmer body with a slightly damp cloth and
then wipe it dry.
– Never use solvents or abrasives to clean the unit body
and attachments.
STORAGE
– Clean the unit before taking it away for storage.
– If you are not planning to use the unit for a long time,
remove the battery from the battery compartment.
– Keep the unit in a dry cool place away from children and
disabled persons.
DELIVERY SET
Trimmer – 1 pc.
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: an «AA» type battery, 1.5 V (not included)
ENGLISH
5
05.02.2018 15:15:35