Specifications - Makita 4131 Instruction Manual

ENGLISH (Original instructions)
1-1. Lever
1-2. Depth guide
2-1. Cutting line
3-1. Switch trigger
3-2. Lock-off button
4-1. Switch trigger
5-1. Dust cover
5-2. Knob
6-1. Hex wrench
6-2. Shaft lock

SPECIFICATIONS

Max. cutting capacity
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Pay attention! It may become too hot.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.
Intended use
The tool is intended for cutting in mild steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
Explanation of general view
7-1. Hex socket head bolt
7-2. Outer flange
7-3. Carbide-tipped saw blade
7-4. Inner flange
8-1. Slot
8-2. Rib
9-1. Rip fence (Guide rule)
9-2. Screw
10-1. Carbide-tipped saw blade
10-2. Workpiece
Model
Blade diameter
-1
)
Overall length
Net weight
Safety class
Electric and
END209-5
from sockets without earth wire.
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Vibration
The vibration
determined according to EN60745:
Electronic
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
ENE022-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENF002-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
4
11-1. Sight window
11-2. Workpiece
12-1. Retracting lever
13-1. Sight window
14-1. Dust cover
14-2. Knob
15-1. Limit mark
16-1. Screwdriver
16-2. Brush holder cap
4131
185 mm
63 mm
3,500
358 mm
5.1 kg
/II
A-weighted noise level
) : 89 dB (A)
pA
) : 100 dB (A)
WA
Wear ear protection
total value (tri-axial
) : 2.5 m/s
h,M
2
ENG905-1
determined
ENG900-1
vector sum)
2
or less
ENG901-1