Operation Of Snow Plow Lights Using The Energy Smart System With Procontrol 2 Plus™ (For Vehicles That Use A Snow Plow Interface Module Kit); Start/Stop Procedure For Procontrol 2 Plus™ Transmitters; Power Saving Mode; Diagnostic Functions - Sno-Way PROCONTROL 2 PLUS Installation & Owner's Manual

NOTICE
PLACE THE VEHICLE HEADLIGHT SWITCH TO
OFF WHEN FINISHED USING THE EQUIPMENT.
LEAVING THE VEHICLE HEADLIGHT SWITCH IN
THE PARK POSITION
BATTERY.
FAILURE TO FOLLOW
PROPERTY DAMAGE.
Operation of Snow Plow Lights Using The
Energy Smart System with ProControl 2
Plus™ (For Vehicles that use a Snow Plow
Interface Module Kit)
Use the manual supplied with your vehicle's specific Snow
Plow Interface Module (SPIM) Kit.
Start/Stop Procedure for ProControl 2
Plus™ Transmitters
To prevent the ProControl 2 Plus™ transmitter from
inadvertently and accidentally being switched off the
power button is to be held approximately 2 seconds to be
turned off.

Power Saving Mode

The ProControl 2 Plus™ transmitter uses a very small
amount of electrical current anytime it is' On'. To minimize
current use when the ProControl 2 Plus™ transmitter is
inactive, the system has a 'Sleep' mode to shut itself
down. If no control function is pressed for a time period of
approximately 20 minutes, the ProControl 2 Plus™
transmitter will shut down by itself. When this happens,
the power button must be pressed and held to switch the
transmitter back "ON."
WILL DRAIN THE
COULD LEAD TO

Diagnostic Functions

The Transmitter, Plow Receiver, and Vehicle Receiver
has built in diagnostic capability. The following charts list
common visual signals and what they indicate.
TRANSMITTER
LIGHT
INDICATION
BACK LIGHT ON
BACK LIGHT
FLASHING
DP LIGHT FLASHES 4
TIMES
DP LIGHT FLASHES
ALTERNATELY WITH
BACK LIGHT 4 TIMES
SALT LIGHT AND DP
LIGHT FLASH
TOGETHER 4 TIMES
OR ON SALT ONLY
CONTROL SALT
LIGHT FAST FLASHES
4 TIMES
SALT LIGHT FLASHES
4 TIMES
SALT LIGHT FLASHES
ALTERNATELY WITH
BACK LIGHT 4 TIMES
PLOW RECEIVER
LIGHT
INDICATION
RED FLASHING LED
GREEN FLASHING
LED
LED FLASHES GREEN
1 TIME AND THEN
FLASHES RED ON
POWER UP
LED FLASHES GREEN
2 TIMES AND THEN
FLASHES RED ON
POWER UP
LED FLASHES GREEN
3 TIMES AND THEN
FLASHES RED ON
POWER UP
DESCRIPTION
TRANSMITTER IS
TURNED ON
CONTROL ERROR
SEE DEALER
COMMUNICATION
ESTABLISHED WITH
PLOW RECEIVER
COMMUNICATION LOST
WITH PLOW RECEIVER
SPREADER JAM
COMMUNICATION
ESTABLISHED WITH SALT
SPREADER RECEIVER
COMMUNICATION LOST
WITH SPREADER
RECEIVER
DESCRIPTION
RECEIVER HAS POWER
NO COMMUNICATION
WITH TRANSMITTER
RECEIVER HAS POWER
AND COMMUNICATION
WITH TRANSMITTER
RECEIVER CONFIGURED
FOR STRAIGHT PLOW
RECEIVER CONFIGURED
FOR WING PLOW
RECEIVER CONFIGURED
FOR V-PLOW
13