Loading WAV Files from USB Flash
Drive
WAV files saved to USB flash drive can be imported
to this instrument as samples and registered to the
QUICK SAMPLING pads.
NOTE
• Available file formats are monaural or stereo PCM (WAV) of
44.1 kHz with 16 bit.
IMPORTANT
• If the instrument is in the Quick Sampling mode, press the
[CAPTURE] button to exit from the mode. And then, follow
the steps below.
NOTICE
• The importing operation overwrites and erases previously
existing samples. Save important samples you want to
keep to a USB flash drive
(page
1
While holding down the [SHIFT] button,
press the [FUNCTION] button to call up
the File Control display.
Keep holding down.
2
Rotate the dial until "Imp.WAV" is shown
on the display.
Imp.WAV
3
Press the [ENTER] button.
"PressA-D" is shown on the display. When there
are no WAV files in USB flash drive, "NoFile" is
shown instead and return to the display of step 2
above.
4
Press one of the QUICK SAMPLING pads
to register the WAV file.
5
Select a file to import by rotating the
dial.
6
Press the [ENTER] button again.
"LoadOK?" is shown on the display. Press the
[EXIT] button to cancel loading and return to the
display of step 2 above.
23).
USB Flash Drive Operations
7
Press the [ENTER] button once again to
execute the load operation.
"Loading" is briefly shown on the display, and the
WAV file is imported as a sample and registered
to the pad.
8
Press the [FUNCTION] button to exit
from the File Control display.
9
Try the loaded samples.
To play back the sample, press the pad to which
the loaded sample was registered.
PSR-E473, PSR-EW425 Reference Manual
27