Bissell PROHEAT2X 8920 User Manual page 11

O
perations
Carpet cleaning continued
8. Remove the tank from the base of the
machine by lifting up on the tank carry
handle. carry like a bucket to a utility
sink or outside where you will dispose
of the dirty water.
8a. unlatch the top of the tank from the
bottom by lifting up on the tank latch
located on the back of the tank.
8b. Remove the top of the tank by lifting
up on the handle.
Note how the lip on the top tank
separates from the groove in the
bottom tank. This placement is
important when putting the tank
back together.
8c. lift the bottom portion of the tank;
pour out dirty water in the sink through
the triangular shaped opening in the
corner of the tank.
Note: You may notice hair & debris
deposits on the carpet or in the tank
that were loosened by the cleaning
action. This debris should be picked
up and thrown away. Check the red
lint filter inside the tank for debris
and remove before continuing.
8d. fill the heavy duty bladder with clean
hot tap water, following instructions
1c through 1e on page 9.
Note: Remember to secure the
tank latch in the back and test
to make sure it is secure before
picking up the tank. Always
check the level of cleaning formula
in the formula tank at the same
time, and refill as needed.
9. Water rinse (recommended). Rinsing
is an optional step that can be done
during the cleaning process or after
the carpeted area has been completed.
switch to the water rinse setting, on
the custom clean dial and follow the
same path as you did for cleaning. take
care to do a forward (wet) stroke by
depressing the trigger, and a backward
(wet) stroke, followed by a forward and
backward (dry) stroke, releasing the
trigger. continue this until the water you
see coming up the nozzle is clear. (see
page 16 for more machine care tips.)
w w w . b i s s e l l . c o m
8.
8b.
8c.
8d.
8 0 0 . 2 3 7 . 7 6 9 1
8a.
9.
11