Bissell PROHEAT2X 8920 User Manual page 10

O
perations
Carpet cleaning continued
2. Remove formula tank from back of
machine.
3. fill the formula tank by first unscrewing
the cap and insert. always use genuine
bissell 2X formulas to maximize
cleaning and for the safety of your
machine. fill with water to WateR
line and then fill up to foRmula line
with bissell 2X concentrated formula.
Replace formula tank.
4. set custom clean dial. simply choose
one of the 4 settings (heavy traffic,
normal clean, light clean, or water rinse).
5. set Readytools dial to the floor
cleaning setting.
6. plug into a proper outlet and turn the
power and heater switches to the on
( i ) position. allow 1 minute for the
built-in heater to warm-up before
cleaning. the pRoheat 2X will be fully
warmed and will provide optimal per-
formance after a minute of continuous
heated cleaning.
7. cleaning strokes. While pressing the trig-
ger, make one slow forward wet pass and
another one back. Caution: Do not
overwet. take care not to run over loose
objects or edges of area rugs. stalling
brush may result in premature belt failure.
Note: Your machine is equipped
with a circuit breaker that will
automatically shut off the brush if
a large or loose object is caught
in the brush roll. If that happens,
be sure to unplug your machine,
remove the foreign object, and
then plug the machine back in to
reset the circuit breaker.
Release the trigger and make one slow
forward and backward pass over the
same area to remove any residual dirty
water and aid in drying. Repeat
cleaning passes until solution being
pulled up appears clean. continue passes
without pressing the trigger until you can't
see any more water being pulled up.
10
w w w . b i s s e l l . c o m
2.
4.
OR
5.
6.
Power Switch
WARNING:
to reduce the risk of fire and
electric shock due to internal
component damage, use only
bissell cleaning fluids intended
for use with the deep cleaner.
3.
Heater Switch
8 0 0 . 2 3 7 . 7 6 9 1