Troubleshooting; Please Do Not Return This Product To The Store - Bissell 37000 User Manual

T
roubleshooting
Reduced Spray OR No Spray
Possible causes
1. Bladder may be empty
2. 2-in-1 tank may not be seated properly.
3. Pump may have lost prime.
4. The pump belt may be broken.
A.
DirtLifter PowerBrush Does Not Turn
Possible causes
1. The brush belt or pump belt is off or broken.
Cleaner Not Picking Up Solution
Possible cause
1. ReadyTools dial may be on the wrong setting
2. Poor tool position. (Hand held attachments only).
3. Removable nozzle may not be properly attached.
4. 2-in-1 tank lid is not properly installed.
5. 2-in-1 tank is not properly seated.
6. 2-in-1 tank has picked up maximum dirty water.
7. The lint screen may be clogged
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

w w w . b i s s e l l . c o m
B.
Slots Pump Belt
WARNING:
To reduce the risk of fire, electric shock or
injury, unplug from the outlet before servicing.
Remedies
1. Turn power switch OFF; Refill bladder
with clean hot tap water.
2. Turn power switch OFF; remove tank
and reseat tanks.
3. Turn power switch OFF; after 1 minute
turn ON and depress spray release trigger.
4. Turn power switch OFF and unplug from the outlet. To
check if a pump belt has broken, you will need a flat
head screwdriver.
A. Insert the blade end into the slot of the belt access
door to release. Examine the belt for breakage. You
should be able to see the pump belt looped around the
motor shaft. If it is broken or missing, please refer to
Replacement Parts on page 14. A replacement belt may
be ordered by calling BISSELL Consumer Services
Complete installation instructions will accompany the
replacement belt.
B. When replacing belt access door be sure to line up
slots of belt access door with slots in machine,
slide door into place and snap shut.
Remedies
1. Refer to Remedy 4 above to check if brush
belt or pump belt is broken.
Remedies
1. Set ReadyTools dial to either FLOOR CLEANING or
TOOLS.for the cleaning job.
2. Adjust angle; apply more downward pressure.
3. Make sure nozzle is on correctly by slightly raising
front of machine to line up slots on the base of
the machine with the hooks on nozzle. Attach at
base first and then click nozzle into place. Refer to
image 5 on page 9.
4. Re-install lid; refer to the image on page 8.
5. 2-in-1 tank must be firmly seated to function;
remove and reseat 2-in-1 tank.
6. Empty 2-in-1 tank and refill, refer to the
Operation section.
7. Clean out lint screen. Refer to page 9.
13