Bosch Professional GLL 2-10 Original Instructions Manual page 26

26 | English
Assembly
Inserting/changing the batteries
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
To open the battery compartment cover (11), press on the locking mechanism (12) and
remove the battery compartment cover. Insert the batteries.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
If the batteries become weak, the status indicator (7) will flash. The measuring tool can
still be operated for approximately 1 hour after the first flash.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it for a pro-
u
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage in the measuring tool.
Working with the RM 1 rotating mount (see figures A–B)
Using the rotating mount (13), you can rotate the measuring tool 360°. This enables you
to set up the laser lines precisely, without having to change the position of the measuring
tool.
Place the measuring tool with the guide groove (17) on the guide rail (14) of the rotating
mount (13) and slide the measuring tool all the way onto the platform.
To disconnect the measuring tool, pull it off the rotating mount in the opposite direction.
Rotating mount positioning options:
– Standing on a flat surface,
– Screwed to a vertical surface,
– On metallic ceiling strips using the ceiling clip (18),
– On metallic surfaces using the magnets (16).
Keep your fingers away from the rear side of the magnetic accessory while at-
u
taching the accessory to surfaces. The strong pulling force of the magnets may jam
your fingers.
1 609 92A 7AN | (14.12.2021) Bosch Power Tools