Maintenance; Changing The Internal Light; Care When Handling; Installation - Sandstrom SWC32B11E Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 21

Maintenance

Changing the Internal Light

All parts removed must be saved to do the
replacement of the light bulb. Before removing
the light bulb, either unplug the wine cooler or
disconnect the electricity from the main power
supply. Failure to do so could result in an electrical
shock or personal injury.
1. Remove the screw with a Philips screw driver.
2. Remove the light bulb cover by pulling the bottom end of the light bulb cover gently.
3. Remove the screw on the light bulb panel.
4. Replace with a 3 Watts bulb panel that is the same shape and size, and then tighten the screw.
5. Replace the light bulb cover and then tighten the screw.

Care When Handling

Hold the wine cooler around its sides or base when moving it. Under no circumstances should it be lifted
by holding the edges of the top surface.

Installation

Don't cover or block the sides of your wine cooler.

Servicing

This wine cooler should be serviced by a qualified technician and only genuine spare parts should be used.
Under no circumstances should you attempt to repair the wine cooler yourself. Repairs carried out by
inexperienced persons may cause injury or serious malfunctioning.

Switching Off for Long Periods of Time

When the wine cooler is not in use for a long period of time, disconnect it from the mains supply, empty all
wine and clean the wine cooler, leaving the door ajar to prevent unpleasant smells.

Disposal

Old units still have some residual value. An environmentally friendly method of disposal will ensure that
valuable raw materials can be recovered and used again. The refrigerant and insulation materials used
in the unit require special disposal procedures. Ensure that none of the pipes on the back of the unit are
damaged prior to disposal.
Up to date information concerning options of disposing of your old unit and packaging from the new one
can be obtained from your local council office.
If your unit is fitted with a lock, to prevent children being trapped inside, keep the key out of reach and not
in the vicinity of the unit.
When disposing of an old unit break off any old locks or latches and remove the door as a safeguard.
GB
31

Advertisement

Table of Contents
loading

Table of Contents