Quick Instructions For Daily Use - Beko D2 7101E Owner's Manual

6

Quick instructions for daily use

Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the "On/Off" button.
2. Select the program and the
temperature.
3. If desired (according to your
machine's model):
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press "Start/Pause/Cancel" button.
The display shows the time remaining
for the program to complete if time delay
is not set.
The display shows the time remaining
for the program to start if the time delay
is set.
6. Check if the Door Locked Symbol
lights up on the screen.
The Door Locked Symbol (Figure 3-13i)
will light up if time delay is not set.
The Door Locked Symbol (Figure 3-13i)
will fade if time delay is set.
Cancelling a program
1. Press and hold the "Start/Pause/
Cancel" button for about 3 seconds;
the Start symbol will start flashing.
2. The machine can discharge all
the water or can take in water for
3 times at most to cool down the
clothes and complete discharging
process.
Adding more laundry
•
This is only possible under the
following conditions:
– during time delay,
C You may add or remove laundry
during the time delay (until the
program starts). At the beginning
of a washing cycle (machine allows
adding more laundry during a future
step only if the water level is low
enough to open the loading door or
if the temperature in the machine is
low).
In order to add laundry after the
start-up of the program:
1. Press "Start/Pause/Cancel" button.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press "Start/Pause/Cancel" button.
Program is in rinse hold mode
C This process is shown with the
flashing spin symbol and the
standby symbol which is lit up.
If you wish to spin when the machine is
in this mode:
1. Adjust the spin speed.
2. Press "Start/Pause/Cancel" button.
The program continues, pumps out
the water and spins.
3. The standby symbol fades out and
the start symbol lights up.
If you want to discharge the water
without spinning:
1. Press "Start/Pause/Cancel" button.
2. The standby symbol fades out and
the start symbol lights up.
3. The program continues and only
pumps out the water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Distribute the laundry in your
machine for a balanced load.
2. Select the spin program.
3. Adjust the spin speed.
23
TR