Table of Contents
Advertisement
INSTALLATION
The fan is designed for wall or ceiling mounting with direct air discharge to the ventilation shaft or into the round air duct of
matching diameter (Fig. 2). Fan installation with direct air discharge upwards is not allowed (Fig. 2).
Fan installation sequence:
Step 1.
Cut off power supply and make sure electricity has been turned off (Fig. 3).
Step 2.
Run the power cable to the vent hole (Fig. 4).
Step 3.
Remove the front panel from the fan. Then remove the circuit board cover (Fig. 5).
Step 4.
Mark and drill holes for mounting the fan, fasten the sealing gasket, and then install the fan (Fig. 6-8).
Step 5.
Connect the fan to power mains according to the wiring diagram (Fig. 12-20).
Step 6.
Install the circuit board cover (Fig. 9) and the front panel on the fan casing (Fig. 10).
Step 7.
Supply power voltage to the fan (Fig. 11).
TERMINAL DESIGNATIONS ON WIRING DIAGRAMS
L: phase
N: neutral
S: external switch
9
EN
Advertisement
Table of Contents
