Table of Contents
Advertisement
a) Manual channel selection:
To set the channel selection switch on the receiver, please take a pointed object, e.g. a
ballpoint pen and select the desired channel switch (no. 1 to no. 4) to position "ON".
The selected channel always remains active. Receiver Set to Receiver Set to Receiver
Set to Receiver Set to Channel 1 Channel 2 Channel 3 Channel 4
b) Auto-scan mode:
If there is more than one camera in operation, you can allow the channels to run
through automatically (scan mode). For this just simply select desired channel on each
camera, and adjust the channels to on position on receive accordingly. On monitor
you will see the channel change accordingly at an interval of 5 seconds.
If not all four channels are occupied with cameras, you have the possibility to block
channels which are not occupied (position "OFF") on both camera and receiver. These
will simply be left out in the auto-scan mode.
-The aerial of the radio camera can be adjusted to ensure the best possible
transmission quality. Please rotate them carefully so that they are vertical. The aerial
can only be rotated within a certain range. Do not rotate the aerials over and beyond
the rotation limits with force as they could be destroyed.
-Alter the channel set on the radio camera and on the receiver (channel selection
switches and if transmission is disturbed,) See also "Elimination of disturbances". -To
switch off the devices, proceed in the opposite order to switching them off.
Always pull the plug-in power units out of the mains socket if not used for a
longer period.
Software installation:
CamGard Security System (Home Edition)
1.
Double click on CamGuard installation program.
2.
Select the language you wish to install, and press [Ok].
Advertisement
Table of Contents
