System Requirements; System Installation - Pacific 0534 User Manual

● Select the correct channel which same as camera.
● The receiver is now ready for use.
● While having the USB jack plug into USB port (USB 2.0 recommended) the blue
LED (USB connection LED) will light up. The RED LED is the channel LED.
Conneting the receiver to PC
1. Plug the USB into the USB socket of PC
2. Insert the CD-ROM provided with the package and Install CamGuard software
and Driver
- Pentium IV or above
- 256MB RAM or above
- USB 2.0 port
- CD-ROM drive (for installing driver & software)
- Color Monitor or LCD Display
- Windows X P or above

System Installation

When installing the camera, check the reception of the receiver before final
installation. Have someone hold the camera in the area to be monitored. Have another
person move the receiver to a variety of locations throughout the house to check
reception. If interference or other problems occur, refer to the Troubleshooting Guide.
To install the system, follow these steps:
-Select the channel (Channel 1-4, as indicated on Channel Label) to be used on both
the camera and receiver. NOTE: Make sure the camera and receiver are set to the
same channel (1, 2, 3 and 4).
Channel selection on the camera
To set the channel selection switch on the camera, proceed as follows: -To set the
channel selection switch, please take a pointed object, e.g. a ballpoint pen and select
the desired channel switch (no. 1 to no. 4) to position "ON". The selected channel
always remains active. Only one channel may be activated at one time.
Channel selection on the receiver

System Requirements