Homewerks Worldwide H13L-421-CH Quick Start Manual

BATHROOM FAUCET WITH
PULL-DOWN SPRAY
H13L-421-CH – Chrome finish
H13L-421-BN – Brushed nickel finish
H13L-421-ORB – Oil-rubbed bronze finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A Faucet body
B Pop-up drain assembly
C Mounting nut
D
E
Due to constant design and quality improvements, the product may look
slightly different from the picture.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering
water supply lines.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product. Contact
customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable wrench, supply
lines, silicone, and screwdriver.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 a.m. to 4:30 p.m. CST) for additional assistance or service.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
QUANTITY
Clip
Weight
1
1
2
1 B
1
CAUTION
• If you solder the joints during installation, the seats, cartridges, and
washers must be removed before using a flame or the warranty will
be voided on these parts.
• Cover the sink drain to avoid losing parts.
Installation may vary depending on how the previous faucet was installed.
Supplies necessary for the installation of the faucet are not all included;
however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then
turn on the old faucet to release built-up pressure. When installing the
new faucet, hand tighten the connector nuts. DO NOT OVERTIGHTEN.
Connections that are too tight will reduce the integrity of the system.
A
C
D
E
10-2021