Series 100 Return Authorization Form - Sigma Controls 100 Series Instruction Manual

SERIES 100 RETURN AUTHORIZATION FORM

*****IMPORTANT RETURN/REPAIR INFORMATION*****
SENSORS AND CABLE THAT HAVE BEEN USED IN WASTEWATER OR HAZARDOUS LIQUIDS
MUST BE THOROUGHLY CLEANED BEFORE RETURNING. UNITS RETURNED UNCLEAN WILL
BE CONSIDERED UNREPAIRABLE AND RETURNED TO THE SENDER OR DISCARDED.
NOTE: DO NOT SUBMERGE UNITS FOR CLEANING WITH CABLE CUT OR REMOVED. THIS
WILL ALLOW CLEANING FLUID TO ENTER HOUSING, DAMAGING ELECTRONICS AND
VOIDING THE WARRANTY. (SEE WARRANTY FOR FURTHER DETAILS.)
User Company Name & Address:
Reason for Return:
If Sensor and Cable, specify material in which equipment was installed. (This
will insure proper handling in case liquid has entered sensor body.)
Urgency of Repair:
Calibration desired for sensor or meter:
PO # for Non-Warranty Repairs:
M.S.D.S. if applicable:
NOTE: PLEASE PACK IN ANTI STATIC PROTECTION
SUITABLE FOR SENSITIVE ELECTRONIC DEVICES.
Name & Phone # to contact for
information:
Possible Cause of Problem:
8