Cooling System
Coolant Check and Top Up
DO NOT remove the engine coolant reservoir
cap when the cooling system is hot - escaping
steam or hot coolant could cause serious
injury.
It is recommended that the cooling system should be
checked weekly when the cooling system is cold and with
the car resting on level ground. If the level is lower than
Maintenance
'Min' mark, open the expansion tank cap of the cooling
system and top up coolant, but the level shall not be higher
than 'Max' mark.
Note: Prevent coolant coming into contact with the
vehicle body in adding. Coolant will damage painted
surface.
If the coolant level falls appreciably during a short period,
the cooling system leakage may occur, please have it
serviced in time by a local MG Authorised Repairer.
Coolant Specification
Please use the coolant recommended and certified by
the manufacturer. Refer to 'Recommended Fluids and
Capacities' in "Technical Data" chapter.
Note: In an emergency, top up the coolant reservoir
with a small amount of clean water. However, it should
be noted that this will weaken the anti-freeze and
anti-corrosion protection and reduce the service life
of the coolant. DO NOT refill the cooling system with
anti-freeze of different formulations.
6
237