Installation Instructions - Electrolux EPM09CRC-A1 User Manual

12 www.electrolux.com

5. INSTALLATION INSTRUCTIONS

5.1 Exhausting hot air
In the Cool Mode the appliance must be
placed close to a window or opening so
that the warm exhaust air can be ducted
outside� First position unit on a flat floor
and make sure there's a minimum of 50cm
clearance around the unit, and is within
the vicinity of a single circuit outlet power
source�
1. Extend either side of the hose(Fig�1) and
screw the hose to adaptor A (Fig�2)�
The adaptor A already be screwed
to the hose for this unit�
2. Extend the other side of the hose and
screw it to adaptor B (Fig� 3)�
3. Install the adaptor A into the unit (Fig�4)�
Insert
1
2
Lock
4. Using the 4 buckles on adaptor B to
affix the adaptor into the window slider
kit and seal� (Fig� 5&6)
Fig.1
The hose can be extended from
its original length of 38cm up to
150cm, but it is the best to keep
the length to minimum required�
Also make sure that the hose does
not have any sharp bends or sags�
(Fig� 7)
Fig. 4
Fig. 5
Fig. 6.1
Fig. 6.2