Cleaning The Unit; Troubleshooting - Vitek VT-8551 Manual Instruction

ENGLISH
Unpack the unit completely and remove any
–
advertising stickers that can prevent the unit
operation.
Check the unit for damages; do not use it in
–
case of damages.
Before switching on, make sure that the oper-
–
ating voltage of the power adapter corre-
sponds to voltage of your mains.
SWITCHING ON
Place the unit on a flat steady and dry surface.
–
Insert the power adapter (7) cord connector
–
into the connection socket (6).
Plug the power adapter (7) into the mains
–
socket.
Touch the power switch (1) «
–
tion mode will be switched on and the indica-
tor «Ion» will light up.
Touch the power switch (1) «
–
ionization and fan mode will be switched on
and the indicator «Fan Ion» will light up.
To switch the unit off, touch the power switch
–
(1) « » once more, the unit will be switched
off and the indicators will go out.
The air purifier can operate for a long time,
–
but, just as when operating any other electric
appliance, you have to follow the safety regu-
lations: unplug the unit when you don't need
to use it.
Note:
If the electrostatic collector (3) is not installed
–
or installed improperly, the unit will not switch
on (pic. 1).
Soft crackling during the unit operation is
–
connected with high relative air humidity in
the room, it is normal.

TROUBLESHOOTING

Problem Possible causes
The unit 1. The power adapter is not connected
would not to the mains. The power adapter
switch on connector is not connected to the
socket (6).
2. No voltage in the mains.
3. The electrostatic collector is not
installed or installed improperly.
4. Malfunction of the unit
IM VT-8551.indd 4

CLEANING THE UNIT

Body
Regularly clean the grids (2 and 5), you can
–
use a vacuum cleaner for cleaning them.
Clean the unit body with a slightly damp cloth
–
and then wipe it dry.
Never immerse the unit into water or other
–
liquids.
Do not use abrasives and solvents to clean
–
the unit body.
Cleaning the electrostatic collector (3)
It is recommended to clean the electrostatic col-
lector (3) plates once a week.
Disconnect the power adapter from the
–
», the ioniza- mains.
Remove the electrostatic collector (3) by pull-
–
ing it upwards by the handle (pic. 1). Do not
» again, the touch the plates until you have removed the
remaining static charge. To do this, let the
plates touch any grounded object, such as
water pipe or tap.
Wipe the plates with a slightly damp cloth to
–
remove dust particles (pic. 2); dry the electro-
static collector for some time. Before installa-
tion, make sure that the electrostatic collector
plates are completely dry.
Install the electrostatic collector (3) back to its
–
installation place (4).
STORAGE
Clean and dry the unit body and the electro-
–
static collector before taking the unit away for
long storage.
Keep the unit in a dry cool place away from
–
children and disabled persons.
Solution
1. Plug the power adapter into the mains.
Insert the power adapter connector into
the connection socket (6).
2. To check, plug another appliance into
the same socket.
3. Check whether the electrostatic
collector is installed properly.
4. Apply to an authorized service center
for repairing the unit.
4
21.06.2018 17:23:57