Throttle Linkage - Toro Reelmaster 2300-D Service Manual

Throttle Linkage

1. Verify high engine speed at 3200
the cold start button depressed.
2. If engine speed is out of specification, loosen cap
screw, nut, and throttle cable clamp on the throttle cable
bracket enough to allow the cable to slide freely within
the bracket.
3. Move throttle lever up fully to the high speed posi-
tion.
4. Pull cable toward flywheel end of the engine until the
governor lever on the engine is up against the high
speed adjustment screw. Tighten cap screw and nut se-
curing the throttle cable clamp.
5. Loosen capscrews (1) and nuts (2) securing the
throttle stop (3).
6. With the cold start button depressed, carefully ad-
just low engine speed to 1400
throttle control lever (4); adjust low speed stop screw
if necessary.
7. Make sure throttle control lever (4) is down so the
governor lever on the engine touches the low speed ad-
justment screw.
8. Adjust throttle stop (3) until it contacts the bottom of
the throttle control lever (4). Tighten cap screws (1) and
nuts (2) securing the throttle stop.
9. Make sure governor lever on the engine goes
against the high speed adjustment screw when the
throttle control lever (4) is moved to the high speed posi-
tion. When the throttle control lever is moved to the low
speed position, the governor lever on the engine should
contact the low speed adjustment screw at the same
time the throttle control lever contacts the throttle stop
(3).
Engine
50 RPM with
50 RPM with the
Page 3 – 8
2
4
Figure 9
1. Cap screw
2. Nut
Reelmaster 2300–D/2600–D
1
3
3. Throttle stop
4. Throttle control leve