Advertisement
6.0 Operating Instructions
position.
Lift the stop rod to tilt the machine forward, load the paper against the doors and the side pipe, tap
any loose sheets flush to the doors, Figure 17. You can load the paper to within 5 inches of the top
brace and the padder will still be steady. It's designed to hold a full load but you must leave room at
the top for the clamping bar and clamps.
Place the clamping bar on top of the stack against the doors. If you're padding 2 stacks, they should
be of equal height so you get even clamping. If you're just padding one side, hold the clamping bar in
place until you can bring the clamp down to hold it. Tighten the stack side first and even it out with a
turn on the other side when it needs it, Figure 18.
To bring the Quick Release Clamp down to the Clamping Bar, just squeeze the lock and it will slide
easily, Figure 19 on page 14. The clamp won't come back up without unlocking.
Always lower top section slowly. Do not allow top to free-fall into
Figure 17
Figure 18
6.0 Operating Instructions
13
Advertisement
