Advertisement
side to side in the same direction as the center brace. If necessary, loosen the nut slightly, reposition
the weld-nut and tighten the nut. (Figure 11 on page 10shows the weld-nut in the vertical-lock
position.)
Figure 12 shows the Stopper in the Tilt position.
To release the locking mechanism, lift up on the handle and tilt the top of padder back, Figure 13.
Install a hex nut on each of the two leveling screws and insert through the frame under the table,
Figure 14.
position.
Figure 12
Figure 13
Figure 14
Always lower top section slowly. Do not allow top section to free-fall into
5.0 Assembly Instructions
11
Advertisement
