Advertisement
5.0 Assembly Instructions
Attach the Stop Rod to the bottom of the table with the pin and "E" rings. Use the two remaining 3/8"
washers between the "U" and the brace if necessary to fill the gap, Figure 9.
Thread a hex nut onto the Stop Rod all the way to the top of the threads, Figure 10.
Guide the bottom of the Stop Rod through the hole in the cross brace as you tilt the top of the padder
to the upright position, Figure 11.
Tilt the top back slightly and slide the spacer onto the Stop Rod. Then thread the plated weldnut onto
the Tilt Rod. Adjust the hex nut above the spacer until it and the Tilt Rod will just slide freely into the
hole in the cross brace. Next, tighten the weld nut against the tube. Be sure the weldnut is positioned
10
Figure 9
Figure 10
Figure 11
Advertisement
