Sharp PN-L803C Service Manual page 79

■
How to USE
1) Execute "ServiceToolsLauncher.exe" in the same folder as
that of expanded service tool.
* Library may have not been installed if the execution failed.
Refer to "How to install Service Tool" and install the library.
* In case "User Account Control" window appears, click on
"Allow".
2) Once the service tool is activated, click on necessary key and
start necessary operation.
Key Name
Serial Number Reads/writes the serial number of a
monitor.
Usage Time Reads/writes the Usage Time of a
monitor.
Model Name Reads/writes the model name.
User Setting Value Reads/writes the user data of this
machine.
InfoDisp Report Read system log and temperature log.
InfoDisp Report
Network Updater Write firmware in the display by network
Copy Update files Copy the file for updating the firmware to
the USB flash drive.
White Balance Read/Write white balance settings of the
display.
PN-L803C/80TC3 SERVICE MENU/VARIOUS SETTING TOOL OPERATING PROCEDURES 4- 13
Description
Gamma Used to read/write the gamma setting of
this machine.
Test Pattern Used to display the test pattern for the
image quality control.
Flicker Adjustment Used to adjust flickers.
Touch Panel Used to adjust the touching positions
Calibration when replacing the Touch panel unit.
Sensor checker Check the cut-line or the short-circuit of
the harness and the sensor when there is
a problem with touching.
Visual C++ 2012 Install
Redistributable (x86).
installed, install this at the beginning of
the operation.
■
Controlling the Monitor with a PC
To use "ServiceToolsLauncher.exe", there are two kinds of
following procedures.
1.Connect the RS-232C conversion cable (supplied) to the
RS-232C input terminal on the monitor. Connect the RS-232C
conversion cable (supplied) to the COM port (RS-232C port) on
your computer with an RS-232 cable (straight).
2. Your monitor can be connected to a LAN allowing you to control
it from a PC on the LAN. You can also configure the monitor to
send e-mail notification when it has a problem. The connection
requires a commercially available LAN cable (UTP cable,
Category 5, straight through).
3) Communication setting and ID setting.
Microsoft Visual C++
Whe this is not
2012