Sharp PN-L803C Service Manual page 125

1-3. DISPLAY UPDATE RESULT
The monitor is restarted automatically after all firmware's updates except the Sub firmware update.
When the Sub firmware does not needs to be updated, the Sub firmware is not updated even if this operation is done.
During firmware update, the following OSD is displayed. However, during update of the Sub firmware, there is no message
on the monitor. Therefore, be sure not to turn off the main power during updating of the Sub firmware.
Updating software.
Do not turn off power until
the finish message appears.
1-4. DISPLAY THE CHECKING RESULT
1) When the firmware update by the USB flash drive is finished, the following OSD is displayed. Check that the displayed versions are
correct.
Updating is finished.
The lates firmware versions are as follows.
INTEGRATED VERSION：Ver1.0.2.0
MAIN : Ver1.00
SUB : Ver1.00.10
TPFW : Ver 1.03
TPCON : Ver 1.03
DSD : Ver 1.21
DP RX : Ver1.2.4.117
DPTX : Ver1.1.4.6
KEY : Ver1.00
1) When the firmware update by the network is finished, the following OSD is displayed. Check that the displayed versions are correct.
Updating is finished
<CAUTION>
Do not perform the firmware update and the update of the internal controller at the same time.
PN-L803C_80TC3 FIRMWARE UPDATE PROCEDURES 5 - 2
End...[RETURN]
終了...[RETURN]