Table of Contents
Advertisement
4. Attach the two Wheel Brackets (38) to the Frame (1)
with the two M10 x 25mm Button Head Screws (42)
as shown.
Attach a Wheel (61) to each Wheel Bracket (38) with
an M10 x 45mm Button Head Bolt (59) and an M10
Nylon Locknut (29).
5. Route both Pulse Wires (15) into and up through the
Upright (3) as shown.
Attach the T-handle (10) to the Upright (3) with two
M6 x 16mm Button Head Bolts (54) and two M6
Nylon Locknuts (17).
6. The Console (6) requires two "AA" batteries (not
included). Alkaline batteries are recommended. To
install batteries, turn the console over. Remove the
four M4 x 16mm Screws (34), and separate the
Console from the Console Base (14). Insert two bat-
teries into the battery clip as shown in the inset draw-
ing. Make sure that the negative ends of the bat-
teries (marked "—") are touching the springs in
the battery clip.
Attach a Plastic Tie (9) to the battery clip as shown.
Attach the Console (6) to the Console Base (14) with
the four M4 x 16mm Screws (34), making sure that the
indicated wires are extending from the Console Base.
Be careful not to pinch the wires.
All manuals and user guides at all-guides.com
7
4
61
29
42
38
59
1
5
3
15
6
6
14
Wires
59
54
10
17
Batteries
9
Battery
Clip
34
Advertisement
Table of Contents
