Z3 Technology Z3-DM8168-PCI-RPS Manual page 10

Now, control the Z3-MVP-02 system via serial port.
1. Plug in the serial cable and NULL modem connector from the Z3-MVP-02 to the PC's COM port
2. Open Teraterm on the PC configure it for 115k, 8, N, 1, 0ms/char, 100ms/line
3. Connect a 12V Power supply to the Z3-MVP-02.
Please only use the 12V power supply provided by Z3 for the Z3-MVP-02 player.
4. Connect an HDMI cable from the Z3-MVP-02 HDMI output to the HDMI input on a video monitor
5. Turn on power on the Z3-MVP-02
6. After booting up and running through the beginning of the sequence the H.264 decode demo menu will
appear. Below is a screenshot of the H.264 decode demo terminal console:
+==============================================================+
|
| U - Change H.264 URL
| R - Change resolution
| I - Set input
| B - Set video kbits/sec
| F - Frame rate
+---------------------------------------------------------------------------------------------------------+
| S - Start streaming
| W - Write configuration to flash
| X - eXit to prompt
+==============================================================+
Enter option:
7. On the menu, press U to change the URL to the IP address of the Z3-MVP-02 (The default IP address
of the Z3-MVP-02 is 192.168.1.111), and then press "S" to start streaming
Please note that you must type in "rtp://" before you enter the IP address of the Z3-MVP-02.
8. You should now see video playing on the monitor
*It is possible that you may need to reboot both the Z3-DM8168-PCI-RPS system and Z3-MVP-02
systems if you do not see video on the monitor.
___________________________________________________________________________________________
Z3 Technology, LLC ♦ 4701 Innovation Drive CB103 ♦ Lincoln, NE 68521 USA ♦ +1.402.323.0702
CONFIDENTIAL
Z3 Technology, LLC DM8168-MOD
H.264 decode demo
Current
rtp://192.168.1.111
1080P
HDMI
10000k
60
v03
10
V1.1
Z3-DM8168-PCI-RPS
.