Hyundai TVL-151M Service Manual page 19

----------------------------------------------------------------------------------------------------------------------
3-4-2. Inspection item in VIDEO MODE
1. Required tool; : PM5518 ( PATTERN GENERATOR ) , VTR ( NTSC ) , SCOPE , 간이 JIG1 ,
2. Preliminary item : 1) set up PM5518 : RF FREQ' :55.25MHZ , PATTERN : COLOR BAR ,
SOUND : STEREO ( 3KHZ/1KHZ )
SYSTEM : PAL/NTSC - 6 ( REAR PANEL ) RF GAIN : 60dBuV
3. Insepction procedure :
1) Inserting Connector
2) Power on JIG , and then POWER ON the set. ( Check the color of LED : GREEN )
3) Inserting RCA-JACK BLOCK S-VHS JACK & PC AUDIO JACK.
4) After converting to VIDEO MODE , check the screen & Sound .
5) In the screen of SCOPE check that the output is L : 3KHZ , R : 1KHZ
6) With S.MODE KEY of Remote control , after converting to MONO , check the SOUND
( L /R :3KHZ )
7) After converting to S-VIDEO MODE , check the screen & SOUND
8) After converting PC MODE, check the output of PC AUDIO
9) After inserting SCART CABLE
10) After converting to STAND BY MODE, check the color of LED ( LED color : RED )
11) Power off JIG , and then disconnect JACK & CONNECTOR
----------------------------------------------------------------------------------------------------------------------
SERVICE MANUAL
TVL-151M / 201M
19