Table of Contents
Advertisement
----------------------------------------------------------------------------------------------------------------------
3-3. Inspection specification of ASSY-CONTROL
1
Turn off the power of JIG ( check the power of JIG )
2
Connect 7P Connector with JIG
3
Check the tight insertion of TACT SW
4
Turn on the power of JIG.
5
Check the color of LED is red
6
Press POWER KEY , and then check the screen is displaying & LED is lighting in green .
7
Press each KEY and check the function
8
With REMOTECON , turn off the power
9
Turn off the power of the JIG
10
Disconnect the Connector
1) After checking the connecting status of 15PIN in JIG , go on the inspection
RMK
: in case of no sign , KEY may not work .
----------------------------------------------------------------------------------------------------------------------
SERVICE MANUAL
Inspection procedure
standard
Tight insertion
STAND BY : RED LED
POWER ON : GREEN LED
CHECK key SW
Check REF LED
TVL-151M / 201M
Remark
16
Advertisement
Table of Contents
