Unit Display; Exit Settings; Display Password Setting - King-Meter SW-U LCD User Manual

KING-METER TECHNOLOGY CO., LTD
No.15, Chenchang Road, Beichen Dist.Tianjin,300134,CN
Fax：+0086 022 8478 0358 Tel: +0086 022 8478 0378
setting parameter can be changed by UP / DOWN.1 is the darkest and 3 is the brightest.

8.2.3 Unit display

Setting parameter of metric /imperial unit can be set,.The display is metric by default.The
metric and imperial unit can be selected by UP / DOWN.

8.2.4 Exit settings

In the setting state, short press the MODE key to confirm the input and enter the next setting;
long press the MODE key to save and exit the setting state.

8.3 Display password setting

Press and hold the UP and DOWN keys for 2 seconds to enter the normal setting state; then
press and hold the UP and MODE keys for 2 seconds at the same time to enter the power on
password setting state.
The screen prompt "PSD. 2" indicates that you need to input the power on password.Short
press the MODE key to shift and input the value through UP / DOWN.After the 4-digit
password is input, press the MODE key to confirm.If the password is correct, enter the
password setting interface, otherwise it will stay in the password input state.Press and hold
MODE to exit.Factory default: 1234.
13