Jeep Cherokee 1988 Quick Start Manual page 11

See FUEL INJECTOR TEST PROCEDURE chart in this article.
REMOVAL & INSTALLATION
COOLANT TEMPERATURE SENSOR (CTS)
Removal & Installation
Drain cooling system. Remove air cleaner assembly.
Disconnect CTS wire connector. Remove CTS from engine block. Install
replacement CTS and connect CTS wire connector. Install air cleaner
assembly. Fill cooling system.
OXYGEN SENSOR
Removal & Installation
Raise and support vehicle. Disconnect O2 sensor wire
connector. Remove O2 sensor from exhaust manifold. Install O2 sensor
and tighten to 30 ft. lbs. (41 N.m). Connect O2 sensor wire connector
and lower vehicle.
KNOCK SENSOR
Removal & Installation
Raise and support vehicle. Disconnect knock sensor wire
connector. Remove knock sensor from cylinder block. Install knock
sensor and connect knock sensor wire connector. Lower vehicle.
SPEED SENSOR
Removal & Installation
Disconnect speed sensor wire connector. Remove 2 speed
sensor retaining bolts at transmission housing. Install speed sensor
and connect speed sensor wire connector.
STARTER MOTOR RELAY
Removal & Installation
Disconnect negative battery cable. Identify, tag and
disconnect wiring to relay. Remove relay retaining screws and remove
relay from inner fender panel. Install replacement relay and connect
relay wires. Connect negative battery cable. Test relay operation.
MANIFOLD AIR/FUEL TEMPERATURE (MAT) SENSOR
Removal & Installation
Disconnect wire connector from MAT sensor. Remove MAT sensor
from intake manifold. To install, reverse removal procedure.
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
Removal & Installation
Disconnect wire connector, vacuum hose, and retaining nuts
from MAP sensor. Remove sensor from firewall. To install, reverse
removal procedure.
FUEL INJECTOR
WARNING: Always relieve residual fuel pressure in fuel delivery
system before opening system. To prevent chance of personal
injury, cover fittings with shop towel while disconnecting
fittings.