Advertisement
Riverside
email: info@riverside-furniture.com
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
4. Install All-Thread Bolts (R-B) into the Headboard (H-A) and the Footboard (F-A) before Carefully
position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and connect using
the Arc Washers (R-F), Flat Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Do not fully
tighten the Nuts until the Footboard has been connected. As shown in ( Detail E )
5. Carefully align the Footboard and headboard to be 'square' with the Side Rails. Fully tighten all the hex
nut (R-C) by using the open wrench (R-G). As shown in ( Detail E ).
6. Attach the four Slat Support Legs (F-C) to the bottom side of four Wood Slats (F-B). (See Detail F).
Position and attach the Slats to the Bed Rails using the Wood Screws (F-D).
7.
The Wood Cleat mounted on the back side of the Bed Rails must be mounted at
the lower location for the Standard Bed. If needed, remove the Bolts and Washers
and remount it at the lower position on the Bed Rails.
F-D
F-B
4 pcs.
F-C
4 pcs.
Detail: F
Myra Bed Room
FURNITURE
Assembly Instructions
Headboard
R-H
Bed rail
R-A
Adjustable leveler
Queen Bed
R-B
Made in Viet Nam
Detail: E
R-F
R-E
R-D
R-C
Bed rail
R-A
Footboard
Page 6 of 7
R-G
Advertisement
