Advertisement
Riverside
email: info@riverside-furniture.com
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used
to perform the following steps.
4. Install All-Thread Bolts (R-B) into the Headboard (H-A) and the Storage Footboard (F-A) before
Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and
connect using the Arc Washers (R-F), Flat Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Do
not fully tighten the Nuts until the Footboard has been connected. As shown in ( Detail E )
5. Carefully align the Storage Footboard and headboard to be 'square' with the Side Rails. Fully tighten all
the hex nut (R-C) by using the open wrench (R-G). As shown in ( Detail E ).
6. Attach the eight Slat Support Legs (F-E) to the bottom side of four Wood Slats (F-D). (See Detail F).
7. Using one of the Support Panels (F-F) as a gauge, locate and position the four Slats so there is a Slat underneath,
centered at the edge of each Support Panel. Attach using the Wood Screws (F-K).
8. Reinstall the Drawers into the Footboard by aligning the metal channels of the guides and push back
into the Footboard.
The Wood Cleat mounted on the back side of the Bed Rails must be mounted
at the upper location for the Storage Bed. If needed, remove the Bolts and
Washers and remount it at the upper position on the Bed Rails.
F-K
F-F
4 pcs.
Myra Bed Room
Queen Storage Bed
FURNITURE
Assembly Instructions
R-H
Headboard
F-D
4 pcs.
F-E
4 pcs.
Detail: F
R-B
Bed rail
R-A
Bed rail
R-A
Adjustable leveler
Page 5 of 7
Made in Viet Nam
Detail: E
R-F
R-E
R-D
R-C
Storage
Footboard
R-G
Advertisement
