Assembly Tips - IBEX TX31 Quick Start Manual

QUICK START GUIDE
TX31 Mini Round Baler with Net Wrap

ASSEMBLY TIPS

 The top part of the metal shipping frame is easily removed to facilitate assembly by
removing the four mounting bolts at the base.
 To install the wheels, the machine must be lifted. Use the two lift hooks on top of the
machine if a loader or forklift of suitable capacity are available. The machine weighs
about 1,100 lbs. If not, the machine can be mounted to and lifted with the tractor's 3
point hitch. The front of the baler must be lifted and raised off of the pin mounting
brackets first.
 Once the baler is free of the frame, it can be fully attached to the 3 point hitch. Raise
the baler up off of the pallet and remove it, then install the wheels. The hardware for
the wheels is in the twine chamber and includes a bolt, washer, and lock nut for each
side. The wheel has two dust cover caps. Be sure these are secure. Medium strength
thread locker is suggested to keep them from coming off.
 The baler is shipped without the net wrap feeding lever installed, to avoid damage
during shipping. Remove the small red guard on the upper part of the machine, on the
right side (left and right are as if the baler is attached to the tractor, and the operator
is sitting on the tractor facing forward). Install the lever as shown in the image below
using the roll pin. Then attach the eye of the lift rod to the outside face of the lever
using the screw, as shown.
2020-1.3 IBEX EQUIPMENT CO