Winter Storage - Tarmo TAR010 Instruction Manual

STORAGE

Winter storage

At the end of the season, the machine should be readied for storage (or if it will not be in use
for longer than 30 days). Fuel allowed to stand for long periods of time (30 days or more) can
leave sticky residues that can plug the carburetor and disrupt engine function.
Fuel stabilizers are an acceptable option as regards sticky residues during storage. If
alkylate gasoline (Aspen) is used, stabilizers are unnecessary because this fuel is stable.
However, you should avoid switching between regular and alkylate gasoline as sensitive
rubber components can harden. Add stabilizer to the fuel in the tank or in the storage
container. Always use the mixing ratios specified by the manufacturer of the stabilizer. Run
the engine for at least 10 minutes after add in the stabilizer so that it reaches the
carburetor. DO NOT empty the fuel tank and the carburetor if you have added stabilizer.
NEVER STORE AN ENGINE WITH FUEL IN THE TANK INDOORS OR IN POORLY VENTILATED
SPACES WHERE FUEL VAPOR CAN COME IN CONTACT WITH OPEN FLAME, SPARKS OR A PILOT
LIGHT SUCH AS IN A BOILER, HOT WATER TANK, CLOTHING DRIER, ETC. HANDLE THE FUEL
WITH CAUTION. IT IS VERY FLAMMABLE AND CARELESS USE CAN CAUSE SERIOUS DAMAGE TO
PERSON AND PROPERTY. DRAIN THE FUEL INTO AN APPROVED CONTAINER OUTDOORS AND
FAR AWAY FROM OPEN FLAME. NEVER USE GASOLINE FOR CLEANING. USE A DE-GREASER AND
WARM WATER INSTEAD.
Service
When ordering spare parts, please specify the purchase year, model, type, and serial
number. Always use genuine Parts.
An annual check-up at an authorized service workshop is a good way to ensure that your
machine performs its best the following season.
1. Inspect the paint to prevent rust.
2. Inspect the machine for worn or damaged parts and tighten any nuts or screws that may
have become loose.
3. Change the engine oil; dispose of properly.
4. Open the fuel valve. Empty the fuel tank and the carburetor.
5. Close the fuel valve.
6. Remove the spark plug and pour about a tablespoon of engine oil in the cylinder. Turn
over the engine so that the oil is evenly distributed and then refit the spark plug. Put the
engine in the compression phase where the triangle mark on the sleeve of the starter is
aligned with the upper hole in the starter. Note: Compression phase occurs every second
revolution.
7. Lubricate all grease nipples, joints and cables.
8. Store the machine in a clean, dry place and cover it for extra protection.
9. Cover the blade and cutters with a thin coat of oil to avoid rust.
WARNING