Tarmo TAR010 Instruction Manual page 71

IMPORTANT INFORMATION
1. Clear the work area before beginning work.(Such as clod, stone, steel bar and so on )
2. Change the engine oil after 10 hours.
3. Check bolts and nuts are properly adjusted after 10 hours, tighten them.
4. When the engine works smelly without cutter spindle rotating, move the cutter spindle
away from work area to avoid belt worn.
5. Check the edge before and after operating. Replace it when damaged.
6. Check fuel tank carefully before and after operating. Make sure there is enough fuel for
using.
After the first 10 hours.
1. Change the engine oil.
2. Check that the clutch is operated well.
3. Check that belts and chains are properly adjusted.
4. Tighten screws and nuts.