Connecting To Power Source - Samsung HZ50W User Manual

Connecting to a Power Source
You should use the rechargeable battery SLB-11A supplied with the
camera. Be sure to charge the battery before using the camera.
SLB-11A rechargeable battery Specifi cation
Model SLB-11A
Type Lithium lon
Capacity 1130mAh
Voltage 3.8V
Charging time Approximately 200 Minutes
Number of images and battery life: Using the SLB-11A
Battery life /
Number of images
Approx. 120 MIN /
Still image
Approx. 240 shots
Movie Approx. 120 MIN
These fi gures are measured under Samsung's standard conditions
and shooting conditions and may vary depending on the user's
methods.
Conditions
Using the fully charged battery,
Default settings, Program mode,
Shot to shot interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the fl ash on every second shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Using the fully charged battery
640x480 image size
30fps frame rate
Important information about battery usage.
When camera is not in use, turn off the power.
Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
Low temperatures (below 0°C) can affect the performance of
the battery and you may experience reduced battery life.
Batteries will usually recover at normal temperatures.
During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Connecting the AC adapter with the USB cable can be used as an
AC cable, and you can charge the rechargeable battery with the
AC cable.
- Using an AC cable:
Connect the AC adapter to the USB
cable. It can be used as a power
cable.
- Using a USB cable:
Remove the AC adapter.
You can download stored images to
your PC (p.108) or supply the power to
your camera through the USB cable.
013